IDEAL LinkMaster PRO Tester
$ 74.49 $ 79.00 In Stock
Condition:
New
Item No.
416231
Mfg Part No.
62-200

Product Information for IDEAL LinkMaster PRO Tester

Highlights for IDEAL LinkMaster PRO Tester

  • Product Type:Network Testing Device

Marketing Information

The LinkMaster PRO Tester enables installers,contractors and maintenance technicians to map, test and troubleshoot data and voice communication cable and coax runs. Rugged, versatile, and easy-to-use, the LinkMaster PRO tester has mastered the link between performance, simplicity and value for both commercial and residential applications.

General Information

  • Manufacturer: IDEAL Industries, Inc
  • Manufacturer Part Number: 62-200
  • Manufacturer Website Address: www.idealindustries.com
  • Product Line: LinkMaster PRO
  • Product Name: LinkMaster PRO Tester
  • Product Type: Network Testing Device
  • Brand Name: IDEAL
  • Technical Information

  • Test Services:
  • Open circuits
  • Shorts
  • Miswires
  • Reversals
  • Split pairs
  • SHIELD detection tests a cable's shield integrity
  • Checks continuity and configuration of wiring with unshielded and shielded modular plugs
  • Remote has wiring chart identifying T568A and T568B wiring configurations
  • DEBUG quickly identifies which cable pairs have a specific wiring fault
  • Length Measurement: 3 ft to 600 ft STP/UTP
  • Battery Information

  • Batteries: AA
  • Power Description

    Environmental Conditions

    Physical Characteristics

  • Dimensions: 3.25" Height x 2" Width x 1.25" Depth
  • Weight: 32 oz - with Battery
  • Miscellaneous

    Warranty

    Management & Protocols

    Controls/Indicators

  • Status Indicators:
  • Battery low LED
  • OPEN - There is no "OPEN" LED indication. A typical cable may have 2, 3, or 4 pairs. OPENS are displayed as an unlit LED. The user will determine if a pair is present and continuous or OPEN by comparing the illuminated LEDs to the expected number of pairs that should be good. Forexample, when testing a 4 pair cable, three illuminated LEDs in the PASS area indicate the presence of an OPEN condition in one of the pairs
  • SHORT - A short circuit condition exists
  • MISWIRE - Indicates the improper assignment of individual wire pairs to pins for the wiring schemes tested. Tester checks T568A, T568B, 10Base-T, and Token Ring configurations
  • REVERSAL - Reverse wiring means the pin for one wire in a pair is connected to the opposite pin for the pair in the remote jack
  • SPLITPAIRS - Split Pairs occur when the tip (positive conductor) and ring (negative conductor) of two twisted pairs are interchanged
  • Pass Indicators:

      T568A and T568B
    • Four green LEDs on pairs 1-2, 3-6, 4-5, and 7-8. All four pairs are terminated correctly
      Token Ring
    • Two green LEDs on pairs 3-6, and 4-5. Both pairs terminated correctly
      10 Base-T
    • Two green LEDs on pairs 1-2, and 3-6. Both pairs terminated correctly
      Shield
    • Green SHIELD LED indicates the shield on the cable is correctly and continuously wired through the modular plug termination

    FAIL Indicators:

  • A flashing pair LED indicates that this wire pair has a fault. A flashing LED in the FAIL section will indicate which fault was detected. Multiple flashing LEDs indicate multiple pairs and/or multiple faults. Best practice is to correct cable faults until cable is verified as correct with appropriate green LEDs
  • Interfaces/Ports

  • Ports: 1 RJ-45 Network
  • Media & Performance

    Memory

    Display & Graphics